And it matters little whether you’re drawing an office building, a helical gear, a map, or a flower. This is the heart of the PowerCADD/WildTools combination, where the distinctions of CAD and illustration vanish in thin air. It’s infinitely more powerful than the typical pen tool, yet also the easiest to use by far. The WildTools Pen tool is unlike any other. The WildTools Fillet tool will fillet anything to anything, thus you can fillet a rotated elliptical arc to a parallel spline inside a group.Īll illustration programs have a tool to draw Béziers, yet without exception they depend on a confusing array of key-press combinations to manipulate the curves. Yet it’s apparent from the beginning that the tools have enormous power and capabilities.įor example, all CAD programs have a fillet tool, which you quickly discover will only work with lines and circles. You can begin to draw immediately, without a glance at the manual, as in the most basic ‘draw’ programs. Perhaps the most remarkable thing about WildTools is how unassuming and familiar they seem at first glance. Steel shapes and sizes from the ‘Steel Book’. You have powerful tools for isometrics and perspectives. That was 20 years ago, and since then the progress continues. Macintosh users finally had drawing tools to make their PC friends green with envy. With WildTools 2.0, the high-end programs were left in the dust. Suddenly users had drawing tools that easily matched or exceeded the capabilities of high-end CAD and illustration programs. Few things created as much excitement in the Macintosh CAD community as the introduction of WildTools for PowerCADD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |